If the fluid you are using in the pipe system does not exist in the Pipe Flow Expert fluid database, you can quickly add the fluid to the database by clicking the Add new fluid data button on the Fluid data screen.


NOTE: Be sure to enter the value for the fluid’s properties in the units displayed on the column header. For example, if you are using imperial units, ºF for Fahrenheit is displayed under Temperature in the Temperature column. The temperature value in this case should be entered in degrees Fahrenheit. 


To add new fluid data to the fluid database:


  1. Click the Fluid button, FluidToolButton.dib, on the tool bar and select ‘Change Fluid’ from the pop-up menu to open the Fluid database.


  1. Click the Add new fluid data button.


  1. Clicking the Add new fluid data button opens the Add fluid data section in the Fluid data screen.


  1. Type the fluid’s name in the Name field.


  1. Type the fluid’s formula in the Formula field.


  1. Type the fluid’s temperature in the Temperature field.


  1. Type the fluid’s density in the Density field.


  1. Type the fluid’s viscosity centipoise in the Viscosity Centipoise field.


  1. Type the fluid’s vapor pressure in the Vapour Press field.


  1. If the fluid’s state is gas, select the Gas check box in the State field.


  1. Leave the Gas check box blank if the fluid’s state is liquid.


  1. Click Save to save the new fluid data to the database and the Fluid Properties Database list.